TCP-IP Controllers
The TCP-IP controllers run on a standard TCP-IP network and use the TCP-IP 4 and 12 way output nodes with standard or large GDS outstations to complete the system. The controllers come in 4, 8 and 12 way as standard, desk or rack mount with larger version available to order.
By using an output node mesh approach to the TCP-IP cue system, single point of failure is significantly reduced as in some serial linked systems.
 |
Software is used for patching of system nodes. Advanced patching such as multiple output channels to one controller eliminate the need for any paralleling circuits. Dynamic patching can be loaded and stored for each show set up allowing for multiple show configurations to be run in each venue at the touch of a button.
 |
| The above diagram demonstrates a typical Digital system connection. |
For larger systems, any number of controllers can be integrated into the TCP-IP cue system with features such as mimic desks for dual operator or monitoring purposes.
Each cue state across the entire system can be stored and replayed using the cue system software. The cues are stacked for show playback and can be easily edited during the show or in rehearsals. An intuitive preview system lets the operator preview up to 4 cues before and after the active cue. The simple use of a 'Go' and 'Back' button triggers all the stored cues, with access to any cue in the stack if required with live editing on the desks or software.
 |
| The diagram above shows a typical theatre system. |
The software has the following features:
- System wide dynamic patching
- Complete programmability for storing of cues
- Simple playback with live editing
- Load/save any number of patch/show files
- RS232 control for triggering stored cues
The Controllers comes standard with professional features such as:
- TCP-IP Network connectivity
- Series operation - so the controller only lights if the outstation does
- Single preset mastering and cancel options for all channels
- Left and right hand mastering for all controllers over 4 channels
- Multi voltage IEC mains input
- Robust Carry handle on desk version
- RS232 on individual channel control
The operation of all controllers can be simply configured in a number of ways:
- Flashing or static operation - for the red standby
- Green Momentary - for latching or non-latching green
- Green Dual Function - push and hold or latching
- Lose red on go - keep or lose red standby after a go
- Red Toggle - Bring back red after a go
- Clear Preset - Clear or keep preset after a go
Where to Buy
To purchase this equipment, please call Global Design Solutions:
UK Sales SalesUK@gds.uk.com
+44 (0)117 325 0063
US Sales SalesUS@gds.uk.com
+1 201 824 5082
